Skip to content

Home Crown molding

Crown Molding Calculator in 3D

Set the wall corner and the angle at which the crown sits against the wall. Read both compound saw settings together, then separate the joint to see how the two pieces meet.

Explore This Calculator

Your Corner

Miter Setting31.62°Magnitude from square
Bevel Setting33.86°Magnitude from vertical
Crown Molding Calculator in 3D with measured dimensionsDrag to Rotate

The complete inside corner, with the crown held at the entered spring angle.

Ceiling Projection3.23 in
Wall Drop4.14 in

Flat cut: miter = atan(sin S ÷ tan(C/2)); bevel = asin(cos S × cos(C/2)).

Angles are magnitudes for flat compound cuts at an inside corner. Left/right saw direction depends on the piece, fence orientation and retained side. Verify a test joint on offcuts. The illustrated profile represents the entered spring angle; face width is the straight wall-to-ceiling distance.

Two Ways to Hold the Same Crown

Flat compound cutting combines a miter rotation with a blade bevel. Nested cutting holds the crown at its installed angle, so the spring angle is already built into the setup.

The numbers here describe an inside corner. An outside corner needs the correct retained side and orientation for the actual molding. Dry-fit a pair before making finished cuts.

Setup Miter magnitude Bevel magnitude
Crown laid flat 31.62° 33.86°
Crown nested at its spring angle 45° 0°

38° from the Wall Is 52° from the Ceiling

The spring angle is measured from the wall, not from the ceiling. A 38° crown and a 45° crown therefore need different compound settings at the same 90° corner.

M = atan(sin S ÷ tan(C/2))
B = asin(cos S × cos(C/2))

S is the spring angle from the wall; C is the inside wall angle.

Crown Molding Calculator · Separate the Joint Crown Molding Calculator · Separate the Joint Current geometry · Use the 3D dimension labels for measurements